中国机械工程 ›› 2015, Vol. 26 ›› Issue (16): 2244-2248.

• 机械基础工程 • 上一篇    下一篇

RZS盘式制动器制动倍率的研究(续)

夏德茂;奚;鹰;华滨滨;朱文翔   

  1. 同济大学,上海,201804
  • 出版日期:2015-08-25 发布日期:2015-08-25
  • 基金资助:
    国家自然科学基金资助项目(61004077)

Study  on  Braking  Rate  of  Disc  Brake  Unit   RZS(Continue)

Xia Demao;Xi Ying;Hua Binbin;Zhu Wenxiang   

  1. Tongji University,Shanghai,201804
  • Online:2015-08-25 Published:2015-08-25
  • Supported by:
    National Natural Science Foundation of China(No. 61004077)

摘要:

依据RZS盘式制动器的工作原理,建立了其机构运动简图;计算和比较了该机构在有无制动盘情况下的自由度;考虑闸调机构伸长量的影响,研究了该制动器在闸片间隙等于设定值和闸片间隙补偿后制动倍率的变化情况。研究结果表明:RZS盘式制动器的制动倍率符合工程设计要求;闸调机构的伸长量与闸片磨损量存在线性变化关系;在闸片的整个服役周期内,制动倍率几乎不变。

关键词: 盘式制动器, 制动倍率, 闸片间隙, 闸调机构, 磨损

Abstract:

Firstly,according to the working principles of the braking unit RZS,the kinematic diagram was built up.Then,the DOF of RZS with and without the brake disc was analyzed and compared.The braking rate and its change rules were  calculated and analyzed respectively  under two conditions:the pad clearance was equal to the setting value and  another the pad clearance was reset after braking operation. It is found that:the braking rate of RZS meets the design requirements and there is a linear relationship between the increment of the self-adjustment mechanism and the amount of the pad's  wear.During the entire service life of the pad, the braking rate of RZS barely changes.

Key words: disk brake unit, braking rate, pad clearance, self-adjustment mechanism, wear

中图分类号: