中国机械工程

• 机械基础工程 • 上一篇    下一篇

DN63位移随动式超高压比例插装阀的建模

张晋1,2,3;薛雄伟1;寇成浩1;姚静1,3;孔祥东1,3;李昊4   

  1. 1.燕山大学机械工程学院,秦皇岛,066004
    2. 南京工程学院机械工程学院,南京,211167
    3. 燕山大学河北省重型机械流体动力传输与控制实验室,秦皇岛,066004
    4. 燕山大学车辆与能源学院,秦皇岛,066004
  • 出版日期:2019-10-25 发布日期:2019-10-29
  • 基金资助:
    国家自然科学基金资助项目(51575471);
    河北省自然科学基金资助项目(E2018203028);
    流体动力与机电系统国家重点实验室开放基金资助项目(GZKF-201716);
    河北省军民融合产业发展专项资金资助项目(2018B070)

Modeling of DN63 Displacement-follower Ultra High Pressure Proportional Cartridge Valves

ZHANG Jin1,2,3;XUE Xiongwei1;KOU Chenghao1;YAO Jing1,3;KONG Xiangdong1,3;LI Hao4   

  1. 1. School of Mechanical Engineering,Yanshan University, Qinhuangdao, Hebei, 066004
    2. Institute of Mechanical Engineering, Nanjing Institute of Technology, Nanjing, 211167
    3. Hebei Province Key Laboratory of Heavy Machinery Fluid Power Transmission and Control,Yanshan University, Qinhuangdao, Hebei, 066004
    4. School of Vehicle and Energy, Yanshan University, Qinhuangdao, Hebei, 066004
  • Online:2019-10-25 Published:2019-10-29

摘要: 以DN63位移随动式超高压比例插装阀为研究对象,考虑摩擦力与伺服阀阀口流量,对其先导部分与主阀部分进行机理建模。通过分析压力和温度变化引起的油液密度和黏度的变化规律来修正机理模型参数,从而提高模型的准确性。利用Simulink对模型进行仿真和试验测试,结果显示两者基本一致,从而验证了模型的正确性。

关键词: 模型, 超高压阀门, 插装阀, 非线性控制系统, 位置控制

Abstract: Taking the DN63 displacement-follower ultra-high pressure proportional cartridge valve as the research object, considering the friction forces and the flows of the valve mouth, the mechanism of the leading part of the displacement servo valves and the main valve parts was modeled respectively. Density and viscosity changing rules of oil caused by ultra-high pressure and temperature changes were analyzed, and the mechanism model parameters were modified to improve the accuracy of the model. The model was simulated by Simulink and was tested by experiments. The results of simulations and tests show that both of them are nearly the same, which verifies the correctness of the model.

Key words: model, ultra-high-pressure valve, cartridge valve, nonlinear control system, position control

中图分类号: