55钢平面磨削中未变形磨屑厚度及单位磨削力的研究

J4 ›› 2009, Vol. 20 ›› Issue (10): 0-1154.

• 机械科学 • 下一篇

55钢平面磨削中未变形磨屑厚度及单位磨削力的研究

王君明;汤漾平;宾鸿赞;冯清秀;熊正鹏

收稿日期:1900-01-01 修回日期:1900-01-01 出版日期:2009-05-25 发布日期:2009-05-25

Research on Undeformed Chip Thickness and Unit 
Grinding Force during Surface Grinding of 55 Steel

Wang Junming;Tang Yangping;Bin Hongzan;Feng Qingxiu;Xiong Zhengpeng


Received:1900-01-01 Revised:1900-01-01 Online:2009-05-25 Published:2009-05-25

摘要/Abstract

摘要：

从简化磨粒形状入手,用解析法对未变形磨屑平均厚度模型进行了修正；通过日本某公司生产的超景深三维显微系统VHX-600测量了磨粒间距,并根据55钢的平面磨削实验,采用非线性回归法推导出了基于未变形磨屑平均厚度的单位磨削力和切向磨削力的经验公式。

关键词: 平面磨削；未变形磨屑厚度；磨粒间距；单位磨削力

Abstract:

Simplifying the geometric shape of abrasive grains,the paper modified the mathematic models of the undeformed chip thickness by analytic method.
The inter-grain spacing was measured with Keyence VHX-600 digital microscope produced in Japan.According to the grinding experiments of steel 55,the experienced equations of tangential grinding force and unit grinding force were built up based on undeformed chip thickness by nonlinear regression analysis. 

Key words: surface grinding;undeformed chip thickness;inter-grain spacing；unit grinding force

中图分类号:

TG580.13

王君明;汤漾平;宾鸿赞;冯清秀;熊正鹏;. 55钢平面磨削中未变形磨屑厚度及单位磨削力的研究[J]. J4, 2009, 20(10): 0-1154.

Wang Junming;Tang Yangping;Bin Hongzan;Feng Qingxiu;Xiong Zhengpeng . Research on Undeformed Chip Thickness and Unit 
Grinding Force during Surface Grinding of 55 Steel[J]. J4, 2009, 20(10): 0-1154.

55钢平面磨削中未变形磨屑厚度及单位磨削力的研究

Research on Undeformed Chip Thickness and Unit 
Grinding Force during Surface Grinding of 55 Steel

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

55钢平面磨削中未变形磨屑厚度及单位磨削力的研究

Research on Undeformed Chip Thickness and Unit  Grinding Force during Surface Grinding of 55 Steel

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

Research on Undeformed Chip Thickness and Unit 
Grinding Force during Surface Grinding of 55 Steel