晶体铜微探针纳米刻划的分子动力学建模

中国机械工程 ›› 2012, Vol. 23 ›› Issue (8): 967-971.

晶体铜微探针纳米刻划的分子动力学建模

张俊杰;孙涛;闫永达;梁迎春;董申

哈尔滨工业大学,哈尔滨,150001

出版日期:2012-04-25 发布日期:2012-05-10
基金资助:
国家自然科学基金资助项目(50575058，50605012)
National Natural Science Foundation of China（No. 50575058，50605012）

Molecular Dynamics Modeling of Probe-based Nanoscratching on Crystalline Copper

Zhang Junjie;Sun Tao;Yan Yongda;Liang Yingchun;Dong Shen

Harbin Institute of Technology,Harbin,150001

Online:2012-04-25 Published:2012-05-10
Supported by:
National Natural Science Foundation of China（No. 50575058，50605012）

摘要/Abstract

摘要：

分别从分子动力学基本原理、晶体铜原子结构建模和晶体缺陷分析三方面开展了晶体铜微探针纳米刻划的三维分子动力学建模研究。研究结果表明：在合理地选择分子动力学模拟参数的基础上，基于晶体结构、重位点阵和维诺图分别建立单晶铜、双晶铜和纳米晶体铜的原子结构模型，并结合先进的晶体缺陷分析技术，可为系统开展晶体铜微探针纳米刻划的分子动力学模拟提供技术保障。

关键词: 纳米刻划, 晶体铜, 分子动力学, 缺陷分析

Abstract:

This paper investigated MD modeling of probe-based nanoscratching on crystalline copper from following three aspects:choosing optimized parameters from fundamental principle of MD simulation;construction of atomic structures of crystalline copper(single crystal,bi-crystal,and nanocrystalline) based on crystal structure,coincidence site lattice,and Voronoi diagram;analysis of defect structure by advanced defect analysis technique.It indicates that the MD modeling presented can enhance the MD simulation of probe-based nanoscratching on crystalline copper significantly.

Key words: nanoscratching, crystalline copper, molecular dynamics(MD), defect analysis

中图分类号:

TG501.1

张俊杰, 孙涛, 闫永达, 梁迎春, 董申. 晶体铜微探针纳米刻划的分子动力学建模[J]. 中国机械工程, 2012, 23(8): 967-971.

ZHANG Dun-Jie, SUN Chao, YAN Yong-Da, LIANG Ying-Chun, DONG Shen. Molecular Dynamics Modeling of Probe-based Nanoscratching on Crystalline Copper[J]. China Mechanical Engineering, 2012, 23(8): 967-971.

参考文献

[1]Zhao X Z,Bhushan B. Material Removal Mecha-nisms of Single--crystal Silicon on Nanoscale and at Ultralow Loads[J].Wear,1998,(1/2):66-78.
[2]Yan Y D,Sun T,Dong S. Top--down Nano-mechanical Machining of Three-dimensional Nanostructures by Atomic Force Microscopy[J].Small,2010,(06):724-728.
[3]陈日曜.金属切削原理[M]北京:机械工业出版社,1993.
[4]Belak J,Lucca D A,Komanduri R. Molecular Dynamics Simulation of the Chip Formation Process in Single Crystal Copper and Comparison with Experimental Data[A].New York,1991.100-109.
[5]Fang T H,Weng C I. Molecular Dynamics Simula-tions of Nano--lithography Process Using Atomic Force Microscopy[J].Surface Science,2002,(1/2):138-147.
[6]Fang F Z,Wu H,Liu Y C. Modelling and Experi-mental Investigation on Nanometric Cutting of Monocrystalline Silicon[J].International Journal of Machine Tools and Manufacture,2005,(15):1681-1686.
[7]Mulliah D,Kenny S D,Smith R. Molecular Dynamic Simulations of Nanoscratching of Silver(100)[J].Nanotechnology,2004,(03):243-249.doi:10.1088/0957-4484/15/3/001.
[8]罗熙淳,梁迎春.单晶铝纳米切削过程分子动力学模拟技术研究[J].中国机械工程,2000,11(8):860-862.
[9]郭晓光[1],郭东明[1],康仁科[1],金洙吉[1].单晶硅纳米级磨削过程的理论研究[J].中国机械工程,2008,19(23):2847-2851.
[10]Jin M,Minor A M,Stach E A. Direct Obser-vation of Deformation--induced Grain Growth dur-ing the Nanoindentation of Ultrafine--grained A1 at Room Temperature[J].Acta Materialia,2004,(18):5381-5387.doi:10.1016/j.actamat.2004.07.044.
[11]Mishin Y,Mehl M J,Papaconstantopoulos D A. Structural Stability and Lattice Defects in Cop-per:Ab Initio,Tight--binding,and Embedded--Atom Calculations[J].Physical Review B,2001,(22):224106.
[12]Zhu P Z,Hu Y Z,Ma T B. Study of AFM--based Nanometric Cutting Process Using Molecu-lar Dynamics[J].Applied Surface Science,2010,(13):7160-7165.
[13]Ziegenhain G,Hartmaier A,Urbassek H M. Pair vs Many--body Potentials:Influence on Elastic and Plastic Behavior in Nanoindentation of FCC Metals[J].Journal of the Mechanics and Physics of Sol-ids,2009,(09):1514-1526.
[14]Tschopp M A,McDowell D L. Structures and En-ergies of 3 Asymmetric Tilt Grain Boundaries in Copper and Aluminium[J].Philosophical Magazine,2007,(22):3147-3173.
[15]Lu L,Sui M L,Lu K. Superplastic Extensibility of Nanocrystalline Copper at Room Temperature[J].Science,2000,(5457):1463-1466.
[16]Du D S,Hwang F. Computing in Euclidean Geometry[M].Singapore:World Scientific Publishing Co.Ptc.Ltd,1995.
[17]Matteoli E,Mansoori G A. A Simple Expression for Radial Distribution Functions of Pure Fluids and Mixtures[J].Journal of Chemical Physics,1995,(11):4672-4677.doi:10.1063/1.470654.
[18]Kelchner C L,Plimpton S J,Hamilton J C. Dislocation Nucleation and Defect Structure during Sur-face Indentation[J].Physical Review B,1998.11085-11088.
[19]Honeycutt J D,Andersen H C. Molecular Dynam-ics Study of Melting and Freezing of Small Lennard--jones Clusters[J].Journal of Physical Chemistry,1987,(19):4950-4963.
[20]Zimmerman J A,Kelchner C L,Klein P A. Surface Step Effects on Nanoindentation[J].Physi-cal Review Letters,2001,(16):165507.
[21]Aekland G J,Jones A P. Applications of Local Crystal Structure Measures in Experiment and Simulation[J].Physical Review B,2006.054104.
[22]Tsuzuki H,Branicio P S,Rino J P. Structural Char-acterization of Deformed Crystals by Analysis of Common Atomic Neighborhood[J].Computer Physics Communications,2007,(06):518-523.doi:10.1016/j.cpc.2007.05.018.