[1]Luis S A. Force Coefficients for a Large Clearance Open Ends Squeeze Film Damper with a Central Feed Groove: Experiments and Predictions[J]. Tribology International, 2014, 71(1): 17-25.
[2]李舜酩, 陈钊, 李彦. 一种挤压油膜阻尼器的动力特性分析[J].振动与冲击, 2009, 28(5): 44-48.
Li Shunming, Chen Zhao, Li Yan. Dynamic Characteristics Analysis on Squeeze Film Damper[J].Journal of Vibration and Shock, 2009, 28(5): 44-48.
[3]黄太平, 田淑芳. 弹性阻尼支承动态特性分析与试验[J]. 南京航空航天大学学报, 1983, 15(3): 22-36.
Huang Taiping, Tian Shufang. Techniques for the Dynamic Test of the Flexible Damped Supports[J]. Journal of Nanjing University of Aeronautics & Astronautics, 1983, 15(3): 22-36.
[4]王震林. 涡轴发动机挤压油膜阻尼器阻尼特性数值与实验研究[D]. 哈尔滨: 哈尔滨工业大学, 2013.
[5]徐宁, 王旭, 张敏, 等.船用燃气轮机挤压油膜阻尼器阻尼特性试验研究[J]. 热能动力工程, 2012, 27(1): 13-17.
Xu Ning, Wang Xu, Zhang Min, et al. Experimen-
tal Investigation into Dynamic Behaviors of Squeeze Film Damper of Rotor Support System in Marine Gas Turbine[J]. Journal of Engineering for Thermal Energy and Power, 2012, 27(1): 13-17.
[6]徐宁. 舰船燃气轮机转子支撑系统动力学特性研究[D]. 北京: 中国舰船研究院, 2012.
[7]马艳红, 洪杰, 赵福安. 自适应挤压油膜阻尼器减振机理研究[J]. 北京航空航天大学学报, 2003, 29(2): 173-177.
Ma Yanhong, Hong Jie, Zhao Fuan.Vibration Attenuation Mechanism Investigation of an Adaptive Squeeze Film Damper[J].Journal of Beijing University of Aeronautics and Astronautics, 2003, 29(2): 173-177.
[8]周海仑, 冯国全, 罗贵火, 等. 浮环式挤压油膜阻尼器的减振机理分析[J]. 航空动力学报, 2015, 30(04): 966-971.
Zhou Hailun, Feng Guoquan, Luo Guihuo, et al. Research on Damping Mechanism of Floating Ring Squeeze Film Damper[J].Journal of Aerospace Power, 2003, 29(2): 173-177.
[9]Siew C, Hill M, Holmes R. Evaluation of Various Fluid-film Models for Use in the Analysis of Squeeze Film Dampers with a Central Groove[J]. Tribology International, 2002, 35(8): 533-547.
[10]Luis S A, Jeung S-H. Experimental Performance of an Open Ends, Centrally Grooved, Squeeze Film Damper Operating with Large Amplitude Orbital Motions[J]. Journal of Engineering for Gas Turbines and Power, 2015, 137(3): 1-9.
[11]Luis S A, Seshagiri S. Damping and Inertia Coefficients for Two End Sealed Squeeze Film Dampers with a Central Groove: Measurements and Predictions[J]. Journal of Engineering for Gas Turbines and Power, 2013, 135(11): 112503-112503-9.
[12]Luis S A. Damping and Inertia Coefficients for Two Open Ends Squeeze Film Dampers with a Central Groove: Measurements and Predictions[J]. Journal of Engineering for Gas Turbines and Power, 2012, 134(10): 769-778.
[13]Jeung S-H, Luis S A, Bradley G. Forced Coefficients for a Short Length, Open Ends Squeeze Film Damper with End Grooves: Experiments and Predictions[J]. Journal of Engineering for Gas Turbines and Power, 2016, 138(2): 022501-022501-11.
[14]Luis S A, Jeung S H. Orbit-model Force Coefficients for Fluid Film Bearings: A Step beyond Linearization[J]. Journal of Engineering for Gas Turbines & Power, 2016, 138(2) : 022502-022502-11.
[15]Luis S A, Delgado A. Squeeze Film Damper with a Mechanical End Seal: Experimental Force Coefficients Derived from Circular Centered Orbits[J]. Journal of Engineering for Gas Turbines & Power, 2008, 130(4):635-644.
[16]Luis S A, Delgado A. Identification of Force Coefficients in a Squeeze Film Damper with a Mechanical End Seal—Part I: Unidirectional Load Tests[J]. Journal of Engineering for Gas Turbines and Power, 2007, 129(3): 858-864.
[17]Luis S A, Delgado A. Identification of Force Coefficients in a Squeeze Film Damper with a Mechanical End Seal-centered Circular Orbit Tests[J]. Journal of Tribology, 2007, 129(3): 660-668.
[18]周海仑. 含浮环式挤压油膜阻尼器的转子系统动力特性分析[D].南京:南京航空航天大学,2013.
[19]Zhou H L, Luo G H, Chen G, et al. Two Dyn-amic Models of Dual Clearance Squeeze Film Damper and Their Verification[J]. Tribology International, 2013, 66(7): 187-193.
[20]强健. 带浮环的挤压油膜阻尼器特性研究[D].南京:南京航空航天大学, 2011.
[21]闻邦椿, 顾家柳, 夏松波, 等. 高等转子动力学[M].北京:机械工业出版社, 2000.
[22]顾家柳, 丁奎元, 刘启洲, 等. 转子动力学[M].北京:国防工业出版社, 1985.
|