China Mechanical Engineering ›› 2012, Vol. 23 ›› Issue (23): 2869-2874.
Previous Articles Next Articles
Li Qiang;Ai Wu;Duan Chun;Chen Guopei;XiaoYi
Online:
Published:
Supported by:
李抢;艾武;段春;陈国培;肖毅
基金资助:
Abstract:
A kind of fast tool feeding mechanism through linear drive was proposed and the overall design of non-circular turning system was accomplished,which focused on the formation of soft mould of non-circular cross-section parts.A new kind of modeling method of non-elliptic was proposed.Taking the machining of convex oval piston for example,a real convex oval piston model with the maximum ovality of 6mm and the maximum error of 15μm,is processed through fast tool feeding mechanism.The experimental results show that the design completes the taskes of non-circular turning successfully.
Key words: high response, linear motor, motion control card, non-circular turning, rapid feed
摘要:
针对非圆车削加工技术的研究,提出一种直线驱动快速刀具进给机构,构建了非圆车削系统。重点研究了非圆截面零件的软靠模生成,并提出一种非类椭圆的建模方法。以中凸变椭圆活塞为例,利用快速刀具进给机构加工出最大椭圆度为6mm的中凸椭圆活塞试件,误差在15μm以内。实验结果表明,该设计方案能顺利完成非圆车削的任务。
关键词: 高响应, 直线电机, 运动控制卡, 非圆车削, 快速进给
CLC Number:
TG518
LI Cheng, AI Wu, DUAN Chun, CHEN Guo-Pei, XIAO Yi. Research on Non-circular CNC Turning Technology Based on High Response Linear Motor[J]. China Mechanical Engineering, 2012, 23(23): 2869-2874.
李抢, 艾武, 段春, 陈国培, 肖毅. 基于高响应直线电机的非圆曲面加工技术研究[J]. 中国机械工程, 2012, 23(23): 2869-2874.
0 / / Recommend
Add to citation manager EndNote|Ris|BibTeX
URL: http://www.cmemo.org.cn/EN/
http://www.cmemo.org.cn/EN/Y2012/V23/I23/2869