中国机械工程

• 机械基础工程 • 上一篇    下一篇

基于分段变磨削力的磨削强化层仿真

黄向明;李通;任莹晖;吴为;何志坚   

  1. 湖南大学机械与运载工程学院,长沙,410082
  • 出版日期:2017-11-10 发布日期:2017-11-07
  • 基金资助:
    国家自然科学基金资助项目(51475158);
    广东省-教育部产学研合作专项重大项目(2012A090300011)
    National Natural Science Foundation of China (No. 51475158)

Simulation on Grind-hardening Layers Based on Piecewise Variable Grinding Forces

HUANG Xiangming;LI Tong;REN Yinghui;WU Wei;HE Zhijian   

  1. College of Mechanical and Vehicle Engineering, Hunan University, Changsha,410082
  • Online:2017-11-10 Published:2017-11-07
  • Supported by:
    National Natural Science Foundation of China (No. 51475158)

摘要: 分析了磨削强化工艺过程中实际磨削时间以及磨削过程中磨削力的变化规律,提出了分段变磨削力磨削温度仿真方法来预测磨削强化层深度分布。首先对磨削力进行离散,计算相应的热流密度;然后将热流密度按砂轮与工件实际接触长度依次施加到工件的磨削表面,对工件磨削过程中的温度场进行仿真分析,得到了磨削强化层的分布;最后将所提出仿真方法与实验和传统仿真方法进行了比较分析。结果表明,基于分段变磨削力仿真可以更准确地预测工件沿磨削方向的磨削强化层分布。

关键词: 磨削强化, 磨削力, 分段变磨削力仿真, 磨削强化层分布

Abstract: The actual grinding time and the variation of grinding forces during the grinding processes were analyzed. A grinding temperature simulation was put forward to predict the distribution of grind-hardening layer depths based on piecewise variable forces. Firstly, the grinding forces were discretized, and the corresponding heat flow density was calculated. Then, according to the actual contact length between the grinding wheel and the workpiece, the heat flow density was loaded onto the grinding surface, and the temperature field of the workpiece was simulated and analyzed. So the distribution of the grind-hardening layer was obtained. Finally, the comparison and analysis were carried out by the experiments and the traditional simulation method. The results show that the simulation may be more accurate to simulate the distribution of the grind-hardening layers along the grinding directions.

Key words: grind-hardening, grinding force, piecewise variable force simulation, distribution of hardened layer

中图分类号: