中国机械工程 ›› 2022, Vol. 33 ›› Issue (14): 1654-1660.DOI: 10.3969/j.issn.1004-132X.2022.14.003

• 机械基础工程 • 上一篇    下一篇

一种用于鸭翼控制的摇头型双圆环压电马达研究

刘吉磊;陈超;陈恒;王均山;吴树熊   

  1. 南京航空航天大学机械结构力学及控制国家重点实验室,南京,210016
  • 出版日期:2022-07-25 发布日期:2022-07-29
  • 通讯作者: 陈超(通信作者),男,1976年生,教授、博士研究生导师。研究方向为飞行器总体设计。E-mail:chaochen@nuaa.edu.cn。
  • 作者简介:刘吉磊,男,1996年生,硕士研究生。研究方向为气动仿真与弹道控制。
  • 基金资助:
    国家自然科学基金(51575259);中央高校基本科研业务费专项资金(NS2015004)

Research on Rocking Head Type Piezoelectric Motor with Double Annual Plate for Canard Control

LIU Jilei;CHEN Chao;CHEN Heng;WANG Junshan;WU Shuxiong   

  1. State Key Laboratory of Mechanics and Control of Mechanical Structures,Nanjing University of Aeronautics and Astronautics,Nanjing,210016
  • Online:2022-07-25 Published:2022-07-29

摘要: 针对制导弹药平台对舵机的紧凑、直驱等要求,提出了一种采用夹心式换能器诱发双圆环弯曲振动的复合型压电定子结构,由此可构成结构精巧的摇头型双圆环旋转压电马达,用以驱动鸭式舵翼产生特定的偏转运动。该马达中的复合定子主体为一个具有四片压电陶瓷片的夹心式换能器,分别在换能器两输出端设计了利于放大振幅的环形圆盘;夹心式换能器的摇头运动激励出两端环形圆盘的五阶弯曲模态,通过圆环将输出振幅进一步放大;两个圆盘形转子在一定的预压力作用下与复合型压电定子两端的圆环表面保持紧密接触,通过摩擦将圆环表面的椭圆轨迹转换为转子的旋转运动。设计了可用于某制导系统鸭舵偏转操纵的直驱马达结构,建立了基于夹心式换能器的双圆环形定子结构动力学模型,通过有限元软件对定子的模态进行了仿真分析,设计并加工出了样机。搭建了测试平台对样机的输出特性进行了实验,测试结果表明:该双圆环(双)输出轴马达可实现双输出轴同时旋转,在300 V峰峰值的驱动电压下,最大转速可达190 r/min,最大输出扭矩可达0.07 N·m。

关键词: 压电马达, 夹心式换能器, 弯振模态, 舵机, 鸭翼, 摇头型

Abstract: Aiming at the compact and direct drive requirements of rudder actuator for guided ammunitions, a hybrid piezoelectric stator with sandwich transducer inducing bending vibration of double annual plate was proposed. A novel rotary piezoelectric motor might be configured by the proposed stator to actuate the canard wings. Four pieces of piezoelectric ceramics were installed in the middle of the sandwich transducer to excite the bending mode of the stator and the output amplitudes were amplified by two annual plates. The rocking head type vibrations of sandwich transducer excited the fifth-order bending mode of the annual plates at both ends and the output amplitudes might be amplified. Two disk rotors were pressed on the driving surface of the hybrid stator and driven to rotate by the friction interface between the stator and rotors. The rocking head type motor with double annual plates was designed for the actuation of canard wings of a guidance system. The structural dynamics model of the hybrid stator was built, and the vibration mode of the stator was calculated by using the finite element method. Then a prototype of the rocking head type piezoelectric motor with double annual plate was produced. Finally, a test platform was built to study the output characteristics of the motor. Under the driving voltage of 300 V, the maximum speed may reach 190 r/min and the maximum output torque may reach 0.07 N·m.

Key words: piezoelectric motor, sandwich transducer, bending vibration mode, rudder canard wing, canard wing, rocking head type

中图分类号: