一种电磁驱动主动头枕的设计与研究

摘要/Abstract

摘要：

设计了一种电磁驱动主动头枕,采用机电结合的方式,通过连杆机构实现头枕的快速前移。为使头枕具有良好的运动特性和动力特性,设计了驱动滑块的位移规律并反推出电磁驱动器的控制电压。采用分时分区段能量守恒方法,得出了电压曲线中关键点的理论值;通过测试得到了电压试验值,将其与理论值进行对比,结果发现二者的电压变化规律相同。

关键词: 追尾碰撞, 主动头枕, 数学模型, 能量

Abstract:

An electromagnetic driving active headrest was designed, which combined mechanics and electricity to achieve the fast forward displacement of the headrest with the link mechanism. The displacement law of driving slider was designed and the control voltage of electromagnetic actuator was derived in order to make the headrest with good performance of movement and dynamics. The theoretical values of the key points in the voltage curve were obtained by using the energy conservation method in every time and displacement partition. The test values of voltage were obtained through experiments. Compared with the theoretical values, the change rule of them is the same.

Key words: rear end collision, active headrest, mathematical model, energy

中图分类号:

TH113

张盼盼, 尹小琴, 王明霞, 朱喜行. 一种电磁驱动主动头枕的设计与研究[J]. 中国机械工程, 2014, 25(9): 1273-1277.

Zhang Panpan, Yin Xiaoqin, Wang Mingxia, Zhu Xihang. Design of an Electromagnetic Drive Active Headrest[J]. China Mechanical Engineering, 2014, 25(9): 1273-1277.

导出引用管理器 EndNote|Ris|BibTeX

链接本文: https://www.cmemo.org.cn/CN/

https://www.cmemo.org.cn/CN/Y2014/V25/I9/1273

参考文献

[1]万鑫铭，杨济匡，沈斌. 基于虚拟实验方法气囊折叠方式对离位乘员损伤影响的研究[J].汽车工程学报，2005，27(6)：42-46.
Wan Xinming, Yang Jikuang, Shen Bin. Study on the Influence of the Folding Pattern of Airbag to Passenger Based on the Method of Virtual Experiment[J]. Journal of Automobile Engineering, 2005, 27(6): 42-46.
[2]肖志，杨济匡.汽车低速追尾碰撞中乘员动力学响应及颈部损伤的研究[J].中国机械工程，2007，18(10)：1239-1243.
Xiao Zhi,Yang Jikuang. Research on the Dynamic Response and the Neck Injury of Occupant in Low Speed Rear-end Collision[J]. China Mechanical Engineering, 2007, 18(10): 1239-1243.
[3]梁锐.尾碰和复合冲击下乘员颈部损伤及防护研究[D]. 北京：清华大学，2007.
[4]李宗颖. 一种用于车辆座椅的主动式头枕装置[D]. 西安：西北工业大学，2009.
[5]亚历山大 P W，伯格 L A. 利用螺线管和连杆机构传动的主动式头部防护头枕：中国，ZL201010240762.4[P]. 2010-11-02.
[6]杜正义，濮家蔚. 传感器触发的头枕研究：中国，ZL200706037136.2[P]. 2007-06-05.
[7]黄世霖.汽车碰撞与安全[M]. 北京：清华大学，2000.
[8]Hu G, Maker C, Dixon W E. Energy-based Nonlinear Control of under Actuated Euler-Lagrange Systems Subject to Impacts[J]. IEEE Transactions on Automatic Control,2007,52(9)：1742-1748.
[9]Li E, Liang Z Z, Hou Z G, et al. Energy-based Balance Control Approach to the Ball and Beam System[J]. International Journal of Control, 2009, 82(6): 981-992.
[10]孙宁，方勇纯，苑英海.一种基于分段能量分析的桥式吊车镇定控制器设计方法[J]. 系统科学与数学，2011，31(6)：751-764.
Sun Ning, Fang Yongchun, Yuan Yinghai. A Kind of Design Method of Bridge Crane Stabilizing Controller Based on Segmented Energy Analysis[J]. System Science and Mathematics, 2011, 31(6): 751-764.
[11]邓星钟.电磁铁设计手册[S]. 武汉：华中科技大学，2006.
[12]殷小贡，赵志敏. 滤波器三相输入电压的控制与研究[J]. 机械与电子，2002，24(8)：23-25.
Yin Xiaogong, Zhao Zhimin. Study and Control of Filter with Three-phase Input Voltage[J]. Mechanical and Electronic, 2002, 24(8): 23-25.
[13]杨立东，李建军，张超.局部均值分解和经验模态分解的性能对比研究[J]. 汽车技术，2008，16（5）：97-101.
Yang Lidong, Li Jianjun, Zhang Chao. Comparative Study on the Performance of Local Mean Decomposition and Empirical Mode Decomposition[J]. Automotive Technology, 2008, 16(5): 97-101.
[14]宋林锦，钟宏志，张延庆.单变量控制下的定时接触器设计[J]. 机械设计与研究，2011，28(3)：85-87.
Song Linjin, Zhong Hongzhi, Zhang Yanqing. Design of Timing Contactor Based on Single Variable Control[J]. Machine Design and Research, 2011, 28(3): 85-87.
[15]姜琴，刘俊贤. 实验误差分析与检测[M]. 南京：东南大学，2009.