锥形永磁轴承磁力解析模型

摘要/Abstract

摘要：

为了解决锥形永磁轴承缺乏磁力解析模型问题，基于平面点磁荷的磁场和虚功原理，结合两块平行矩形截面永磁体及锥形永磁轴承结构特点，建立了锥形永磁轴承的磁力解析模型，用ANSYS仿真验证了该解析模型的正确性，分析了锥形永磁轴承悬浮磁力与其结构参数之间的关系。研究结果表明：锥形永磁轴承磁力与磁环的平均周长和磁环磁通密度的平方成正比，磁力随着磁环径向宽度的增大而增大，小尺寸范围内随磁环截面长度的增大而增大;轴向磁力随磁环锥角的增大而减小，随轴向偏移的增大而减小。该研究模型为锥形永磁轴承设计计算及其结构参数优化提供了技术支持。

关键词: 锥形永磁轴承, 磁力, 解析模型, ANSYS仿真

Abstract:

To solve the problem about the lack of magnetic force analytic model for CPMB, based on the magnetic field of planar point magnetic charge and on the principle of virtual work, combining two parallel rectangular permanent magnets and the structural characteristics of CPMB，a magnetic force analytic model of CPMB was constructed. The correctness of the magnetic force analytic model was verified by ANSYS simulation, the relationship of CPMB magnetic force and its structural parameters were analyzed. The results indicate that the magnetic force of CPMB is proportional to the average perimeter magnetic ring and the square of residual magnetism induction density, and that the magnetic force increases with an increment in the magnetic annular radial width and sectional length; the axial magnetic force of CPMB increases with decreasing in the conical angle, and with decreasing in the axial offset. The paper provides technical support for CPMB design calculation and optimization of structural parameters.

Key words: conic permanent magnetic bearing(CPMB), magnetic force, analytic model, ANSYS simulation

中图分类号:

TH133.3

田录林, 李鹏. 锥形永磁轴承磁力解析模型[J]. 中国机械工程, 2014, 25(3): 327-332.

Tian Lulin, Li Peng. Magnetic Force Analytic Model of Conic Permanent Magnetic Bearings[J]. China Mechanical Engineering, 2014, 25(3): 327-332.

参考文献

[1]田拥胜,孙岩桦,虞烈.高速永磁电机电磁轴承转子系统的动力学及实验研究[J].中国电机工程学报,2012,32（9）：116-123.
Tian Yongshen, Sun Yanhua, Yu Lie.Dynamical and Experimental Researches of Active Magnetic Bearing Rotor Systems for High-speed PM Machines[J].Proceedings of the CSEE, 2012,32(9):116-123.
[2]Ikeda M, Wongsatanawarid A, Seki H,et al. Interaction of Bulk Superconductors with Flywheel Rings Made of Multiple Permanent Magnets[J]. Physica C, 2009,469:1270-1273.
[3]Deng Z, Lin Q, Wang J, et al. Basic Design and Characteristics Study of a Double-axial Superconducting Magnetic Bearing System[J]. Cryogenics,2009,49:259-262.
[4]Hamler A. Passive Magnetic Bearing[J].Journal of Magnetism and Magnetic Materials,2004(272/276):2379-2380.
[5]Compter J C. Ampere’s Circuital 3-D Model for Noncuboidal Magnets[J]. IEEE Transactions on Magnetics, 2010, 46(12): 4009-4015.
[6]Bassani R, Ciulli E, di Puccio F,et al. Study of Conic Permanent Magnet Bearings[J]. Meccanica, 2001,36:745-754.
[7]冯慈章.电磁场[M].北京:高等教育出版社，2004.
[8]王秀和.永磁电机[M].北京：中国电力出版社，2007.
[9]胡业发,许开国,张锦光,等.磁悬浮风力发电机用磁力轴承的分析与设计[J].轴承,2008(9):6-10.
Hu Yefa, Xu Kaiguo, Zhang Jinguang, et al. Analysis and Design of Magnetic Bearings Used in Magnetic Suspending Wind Power Generator[J]. Bearing,2008(9):6-10.
[10]田录林,李言,安源,等.轴向放置轴向磁化的双环永磁轴承径向磁力研究[J].中国机械工程,2007,18(24):2926-2929.
Tian Lulin, Li Yan, An Yuan, et al. Research on the Radial Magnetic Force of Axial Placement and Axial Magnetization Bi- annular- shaped PMB[J]. China Mechanical Engineering, 2007,18(24):2926-2929.
[11]田录林,张靠社,杨晓萍,等.永磁导轨悬浮和导向磁力研究[J].中国电机工程学报,2008,28(21):135-139.
Tian Lulin, Zhang Kaoshe,Yang Xiaopin,et al. Research on the Axial Magnetic Force of Axially Magnetized Bi-annular-shaped Permanent Magnetic Bearings[J]. Proceedings of the CSEE,2008,28(21):135-139.
[12]田录林，贾嵘,杨国清,等.永磁铁切合体的磁场及磁力[J].电工技术学报，2008,23(6):7-13.
Tian Lulin, Jia Rong, Yang Guoqing, et al. Research on the Magnetic Field and Magnetic Force of a Permanent Magnet Affixed to a Plane Magnetizer[J].Transactions of China Electrotechnical Society, 2008,23（6）:7-13.
[13]田录林,李言,田琦,等.轴向放置的轴向磁化多环永磁轴承径向磁力研究[J].中国机械工程,2008,19(10):1163-1166.
Tian Lullin, Li Yan, Tian Qi, et al. Research on the Radial Magnetic Force of Axial Placement and Axial Magnetization Multiannual-shaped Permanent Magnetic Bearings[J]. China Mechanical Engineering, 2008,19(10):1163-1166.
[14]唐辉.被动磁悬浮轴承及电涡流传感器的研究[D].西安：西安交通大学,2003.
[15]崔鹏,张锟,李杰.基于许-克变换的悬浮电磁铁力与转矩解析计算[J].中国电机工程学报,2010,30(24):129-134.
Cui Peng, Zhang Kun, Li Jie. Calculation of Electromagnetic Force and Torque of Suspension Electromagnet Based on Schwarz-christoffel Transform[J]. Proceedings of the CSEE，2010,30(24):129-134.
[16]Bassani R. Dynamic Stability of Passive Magnetic Bearings[J]. Nonlinear Dyn,2007,50:161-168.
[17]李丽君,房建成,韩邦成,等.磁悬浮风力发电机用锥形被动磁轴承分析与设计[J].轴承, 2010(1):10-14.
Li Lijun, Fang Jiancheng,Han Bangcheng, et al.Analysis and Design of Conic Passive Magnetic Bearing for Magnetic Suspension Wind Turbine[J].Bearing, 2010(1):10-14.
[18]Azukizawa T, Yamamoto S, Matsuo N. Feasibility Study of a Passive Magnetic Bearing Using the Ring Shaped Permanent Magnets[J]. IEEE Transactions on Magnetics, 2008,44(11):4277-4280.