可调减振器阻尼特性试验研究

中国机械工程 ›› 2011, Vol. 22 ›› Issue (23): 2790-2793.

可调减振器阻尼特性试验研究

张莹1;朱思洪1;王家胜2

1.南京农业大学，南京，210031

2.青岛农业大学，青岛，266109

出版日期:2011-12-10 发布日期:2011-12-20
基金资助:
“十一五”国家科技支撑计划资助项目(2006BAD11A02)
The National Key Technology R&D Program（No. 2006BAD11A02）

Experimental Research on Damping Characteristics of an Adjustable Shock Absorber

Zhang Ying1;Zhu Sihong1;Wang Jiasheng2

1.Nanjing Agricultural University， Nanjing,210031

2.Qingdao Agricultural University，Qingdao,Shandong,266109

Online:2011-12-10 Published:2011-12-20
Supported by:
The National Key Technology R&D Program（No. 2006BAD11A02）

摘要/Abstract

摘要：

研制了基于旁通节流孔的新型节流孔可调减振器样机，试验研究了复原阀系活塞孔口直径、复原阀片数、限位阀外径、旁通节流孔直径对减振器阻尼力的影响。试验结果表明：活塞节流孔直径的减小、复原阀片数的增加和限位阀外径的增大都会导致减振器阻尼力增大，其中，活塞节流孔直径和限位阀外径对阻尼力影响较大。在旁通节流孔直径为0~4mm范围内，减振器阻尼力随着旁通节流孔直径的增大而减小，当旁通节流孔直径大于4mm后，减振器的阻尼力变化不大。压缩阻尼力受旁通节流孔直径的影响较小。试验研究结果为旁通节流孔式阻尼可调减振器的设计提供了依据。

关键词:

减振器, 可调阻尼, 节流孔, 阻尼力-速度特性

Abstract:

An orifice-adjustable shock absorber was studied. The effect laws of orifice diameter of piston, number of rebound valve, limit valve outside diameter and bypass throttling orifice diameter on damping force were studied by experimental method. The results show that decreasing orifice diameter, increasing the number of the recovery valve and increasing the limit valve outside diameter all result in the increase of damping force. Of these three factors, orifice diameter and limit valve outside diameter have higher effect on the damping force. As the bypass orifice diameter increases from 0 to 4mm, the damping force decreasing. If the diameter is greater than 4mm, the damping force changes slightly. By-pass orifice diameter has little effect on the compression damping force. The results provide the basis for the design of the bypass orifice-adjustable shock absorber.

Key words: shock absorber, adjustable damping force, orifice-adjustable, damping force-speed characteristic

中图分类号:

U463.33

张莹1, 朱思洪1, 王家胜2.

可调减振器阻尼特性试验研究

[J]. 中国机械工程, 2011, 22(23): 2790-2793.

ZHANG Ying-1, SHU Sai-Hong-1, WANG Jia-Qing-2.

Experimental Research on Damping Characteristics of an Adjustable Shock Absorber

[J]. China Mechanical Engineering, 2011, 22(23): 2790-2793.

参考文献

[1]Fischer D, Isermann R. Mechatronic Semi- active and Active Vehicle Suspensions EJ]. Control Engi- neering Practice, 2004,12 : 1353-1367.
[2]Liu Y Q, Matsuhisa H, Utsuno H. Semi--active Vibration Isolation System with Variable Stiffness and Damping Control[J]. Journal of Sound and Vi-bration, 2008,313 ~ 16-28.
[3]Kitching K J, Cole D J, Cebon D. Theoretical In- vestigation Into the Use of Controllable Suspen- sions to Minimize Road Damage[J]. Proceeding of the Institution of Mechanical Engineers, Part D. , 2000,214:13-31.
[4]Nakano K,Suda Y. Combined Type Self--powered Active Vibration Control of Truck Cabins[J]. Vehi- cle System Dynamics, 2004,41 (6) : 449-473.
[5]Bashtovoi V G, Kahaehnikov D N,Kolobov A Y,et al. Research of the Dynamics of a Magnetic Fluid Dynamic Absorber[J].Journal of Magnetism and Magnetic Materials, 2002, 252:312-314.
[6]Park W C,Choi S B,Suh M S. Material Characteris- tics of an ER Fluid and Its Influence on Damping Forces of an ER Damper Part Ⅰ : Material Charac- teristics[J]. Materials and Design, 1999, 20: 317- 323.
[7]孙胜利.位移相关减振器动力学建模及对车辆性能影响的研究[D].吉林大学,2008:
[8]陈龙.车辆半主动悬架及其控制系统理论与技术研究[D].镇江:江苏大学,2006.
[9]郭洪文.NJ2045越野车可调减振器的研制和半主动悬架设计[D].吉林大学,2004:
[10]Lion A,Loose S. A Thermomechanically Coupled Model for Automotive Shock Absorbers: Theory, Experiments and Vehicle Simulations on Test Tracks[J]. Vehicle System Dynamics, 2002, 37 (4) :241-261.
[11]李世民.筒式液阻减振器液—固耦合动力学特性仿真技术研究[D].清华大学,2004:
[12]Lee C T,Moon B Y. Simulation and Experimental Validation of Vehicle Dynamic Characteristics for Displacement- sensitive Shock Absorber Using Fluid-- flow Modeling [J]. Mechanical Systems and Signal Processing,2006,20(2) :373-388.
[13]周长城[1,2],顾亮[2].减振器节流阀片拆分为多片叠加的设计方法[J].农业工程学报:121-125.
[14]周长城[1,2],任传波[1].最佳阻尼匹配减振器阀片厚度优化设计与特性试验[J].振动工程学报:54-59.
[15]王文林[1],潘双夏[2],等.可调式线性油压减振器阻尼孔的精度设计研究[J].中国机械工程,2002,13(1):12-14.