螺接搭接件的载荷传递特性试验及三维有限元分析

中国机械工程 ›› 2010, Vol. 21 ›› Issue (19): 2273-2278.

螺接搭接件的载荷传递特性试验及三维有限元分析

郁大照;陈跃良;张勇;高永

1.海军航空工程学院,烟台,264001

2.海军航空工程学院青岛分院,青岛,266041

出版日期:2010-10-10 发布日期:2010-10-20
基金资助:
国家自然科学基金资助项目(50675221)
National Natural Science Foundation of China（No. 50675221）

Study on Load Transfer Properties of Bolted Joints Based on Experiments and Three-dimensional Finite Element

Yu Dazhao1;Chen Yueliang2;Zhang Yong2;Gao Yong1

1.Naval Aeronautical and Astronautical University, Yantai,Shandong, 264001

2.Qingdao Branch, Naval Aeronautical and Astronautical University, Qingdao,Shandong, 266041

Online:2010-10-10 Published:2010-10-20
Supported by:
National Natural Science Foundation of China（No. 50675221）

摘要/Abstract

摘要：

在考虑螺栓与孔壁间的非线性接触、摩擦、干涉配合和螺栓预紧力等因素影响的基础上,利用非线性有限元软件MSC.Marc构建了螺接搭接件的三维有限元分析模型。数值模拟结果与试验结果的对比表明：所建三维模型能有效地模拟搭接件的载荷传递特性。基于三维有限元模型,讨论了无裂纹搭接件的螺栓孔形式、干涉配合和螺栓预紧力对载荷传递比的影响规律,同时对含裂纹搭接件的载荷传递比随裂纹扩展的变化规律进行了分析,计算结果和结论可作为该类结构损伤容限设计的参考依据。

关键词:

搭接件, 载荷传递比;有限元法;干涉配合

Abstract:

Three-dimensional finite element model of a bolted joint was developed in the non-linear finite element code MSC.Marc and attempts were made to validate it by comparing results with those of experiments and other finite elements.Experimental measurements of load transfer ratio(LTR) were compared with results from finite element analysis. The results show that the results obtained from three-dimensional finite element model of bolted joint are in close agreement with experimental ones. Three-dimensional finite element analysis assists to study the effects of different parameters on the mechanical behaviour of single lap bolted joints with and without crack. The simulated results may be serving as reference for damage tolerance design of the similar structures.

Key words: lap joint, load transfer ratio, finite element method, interference

中图分类号:

郁大照, 陈跃良, 张勇, 高永.

螺接搭接件的载荷传递特性试验及三维有限元分析

[J]. 中国机械工程, 2010, 21(19): 2273-2278.

YU Da-Zhao, CHEN Ti-Liang, ZHANG Yong, GAO Yong.

Study on Load Transfer Properties of Bolted Joints Based on Experiments and Three-dimensional Finite Element

[J]. China Mechanical Engineering, 2010, 21(19): 2273-2278.