中国机械工程

• 机械基础工程 • 上一篇    下一篇

喷射参数对点燃式重油直喷发动机小负荷性能的影响

贝太学;魏民祥;刘锐;季昊成;常诚   

  1. 南京航空航天大学,南京,210016
  • 出版日期:2016-07-10 发布日期:2016-07-12
  • 基金资助:
    江苏省普通高校博士研究生科研创新计划资助项目(KYLX_0244)

Effects of Injection Parameters on Performance at Low Loads of a Spark-ignited Direct Injection Heavy-oil Engine

Bei Taixue;Wei Minxiang;Liu Rui;Ji Haocheng;Chang Cheng   

  1. Nanjing University of Aeronautics and Astronautics,Nanjing,210016
  • Online:2016-07-10 Published:2016-07-12

摘要: 在一台采用低压空气辅助喷射技术的二冲程点燃式重油直喷发动机上,进行了燃油喷射参数对发动机性能影响的试验研究,研究了中等转速小负荷工况下,喷气结束时刻及过量空气系数对发动机动力性、燃油经济性及排放性能的影响。试验结果表明:节气门开度为10%时,随着喷气结束时刻提前,功率先增大后减小,油耗先减小后增加,HC及CO排放有小幅度减少;混合气由浓变稀时,功率增加,油耗降低,HC及CO排放大幅度减少。节气门开度为20%时,随着喷气结束时刻提前,功率增大,油耗减小,HC排放有小幅度减少,CO排放有小幅度增加;混合气由浓变稀时,油耗降低,HC及CO排放大幅度减少,最大功率出现在理论空燃比附近。

关键词: 点燃式重油发动机, 缸内直喷, 小负荷, 喷油参数, 发动机性能

Abstract: An experimental study on the influences of fuel injection parameters on the engine performance was carried out on a two-stroke engine with low pressure air assisted injection technology, and the effects of inject end time and excess air ratio on engine power, fuel economy and emission performance were studied under the conditions of middle speed under small load. Test results show that at the 10% throttle opening condition, with the end of the inject advance, the power first increases, then decreases, and the fuel consumption first decreases, then increases, and the HC and CO emissions are reduced. When mixed gas is diluted, the power increases, the fuel consumption is reduced, and the HC and CO emissions are reduced significantly. At the 20% throttle opening condition, with the end of the inject advances, the power increases, the fuel consumption decreases, HC emissions have a small decrease, and CO emissions have a small increase. When mixed gas is diluted, the fuel consumption is reduced, the HC and CO emissions are reduced greatly, and the maximum power appears in the stoichiomtric ratio.

Key words: spark-ignited heavy-oil engine, direct injection, low load, injection parameter, engine performance

中图分类号: