宽频压电振动能量采集器的分布参数模型与实验

中国机械工程

宽频压电振动能量采集器的分布参数模型与实验

杨斌强;徐文潭;陆国丽;王光庆

浙江工商大学信息与电子工程学院，杭州，310018

出版日期:2017-01-25 发布日期:2017-01-20
基金资助:
国家自然科学基金资助项目(51277165 );
浙江省自然科学基金资助项目(LF15Y0001)

Distributed Parameter Model and Experiments of a Broadband Piezoelectric Vibration Energy Harvester

YANG Binqiang;XU Wentan;LU Guoli;WANG Guangqing

School of Information and Electronic Engineering，Zhejiang Gongshang University，Hangzhou，310018

Online:2017-01-25 Published:2017-01-20

摘要/Abstract

摘要： 为解决无线传感网络节点自供电问题，提出了一种带有弹性支撑与放大的宽频压电振动能量采集器。利用Hamilton原理和Raleigh-Ritz方法，并考虑悬臂梁末端质量块的影响，建立了压电能量采集器的分布参数机电耦合模型；数值分析了能量采集器质量比、刚度比和阻尼比等参数对系统振动特性、输出特性的影响；研制了实验原理样机，搭建了实验测试平台，验证了数学模型的正确性。研究结果表明，分布参数模型比集总参数模型具有更高的预测精度。

关键词: 压电能量采集, 两自由度, 分布参数模型, 弹性放大器, 宽频带

Abstract: To solve self-power problem of wireless sensor network nodes, a broadband piezoelectric vibration energy harvester with an elastic supporter and amplifier was presented herein. Distributed parameter coupling electromechanical model of piezoelectric vibration energy harvester was established with Hamilton principle and Raleigh-Ritz method by considering the influences of cantilever tip mass. Effects of structural parameters (such as mass ratio, stiffness ratio, and damping ratio) on the vibration performance, the electric output performance of piezoelectric energy harvester were numerically analyzed. Prototype of piezoelectric energy harvester and experimental setup were developed. Some experiments were carried out to testify the validity of the proposed mathematical model. Research results show that the distributed parameter model may obtain higher precision than that of lumped parameter model.

Key words: piezoelectric energy harvester, two degrees of freedom, distributed parameter model, elastic amplifier, wide frequency band

中图分类号:

TH16
TH7

杨斌强, 徐文潭, 陆国丽, 王光庆. 宽频压电振动能量采集器的分布参数模型与实验[J]. 中国机械工程.

YANG Binqiang, XU Wentan, LU Guoli, WANG Guangqing. Distributed Parameter Model and Experiments of a Broadband Piezoelectric Vibration Energy Harvester[J]. China Mechanical Engineering.

参考文献

[1]王光庆，鲍鹏，陆跃明，等. 复合L形宽频压电悬臂梁的建模与仿真[J]. 中国机械工程，2013，24(14)：1933-1938.
WANG Guangqing， BAO Peng， LU Yueming， et al. Modeling and Simulation Analysis for a L-shaped Wideband Piezo-electric Cantilever Beam[J]. China Mechanical Engineering， 2013， 24(14)： 1933-1938.
[2]ERTURK A，INMAN D J. On Mechanical Modeling of Cantilevered Piezoelectric Vibration Energy Harvester[J]. Journal of Intelligent Materials Systems and Structures， 2008，19：1311-1325.
[3]ERTURK A，INMAN D J. A Distributed Parameter Electromechanical Model for Cantilevered Piezoelectric Energy Harvesters[J]. Journal of Vibration and Acoustics，2008，130：2-15.
[4]TANG X D，ZUO L. Enhanced Vibration Energy Harvesting Using Dual-Mass Systems[J]. Journal of Sound and Vibration，2011，330(21)：5199-5209.
[5]ALDRAIHEM O，BAZ A. Energy Harvester with a Dynamic Magnifier[J]. Intelligent Material Systems and Structures，2011，22(6)：521-530.
[6]MA P S，KIM J E，KIM Y Y. Power-amplifying Strategy in Vibration-powered Energy Harvesters[J]. Proc. of SPIE, 2010，7643：764300.
[7]WANG H Y，SHAN X B，XIE T. An Energy Harvester Combining a Piezoelectric Cantilever and a Single Degree of Freedom Elastic System[J]. Journal of Zhejiang University—Science A，2012，13(7)：526-537.
[8]喻其炳，朱荣荣，李川. 多频响应的压电振动能量采集器的性能分析与测试[J]. 中国机械工程，2014，25(15)：2064-2069.
YU Qibing，ZHU Rongrong，LI Chuan. Performance Analyses and Experiments of a Piezoelectric Vibration Energy Harvested with Multifrequency Response Capability[J]. China Mechanical Engineering，2014，25(15)：2064-2069.
[9]王光庆，展永政，金文平，等. 一种宽频压电振动能量采集器的解析模型与试验研究[J]. 机械工程学报，2015，49(6)：198-207.
WANG Guangqing，ZHAN Yongzhen，JIN Wenping，et al. Model and Experiments of a Broadband Piezoelectric Vibration Energy Harvester[J]. Journal of Mechanical Engineering，2015，49(6)：198-207.
[10]ERTURK A，INMAN D J. An Experimentally Validated Bimorph Cantilever Model for Piezoelectric Energy Harvesting from Base Excitations [J].Smart Materials and Structures，2009，18(2)：1-18.