重型汽车变速器润滑系统热平衡仿真与实验

中国机械工程 ›› 2011, Vol. 22 ›› Issue (10): 1242-1246.

重型汽车变速器润滑系统热平衡仿真与实验

阮登芳1;刘波1;陈志约2;张绪勇2;张勇2

1.重庆大学机械传动国家重点实验室，重庆，400030

2.綦江齿轮传动有限公司，重庆，401421

出版日期:2011-05-25 发布日期:2011-05-31
基金资助:
重庆市科技攻关计划项目(2008AB6096，2008AA6024)
Key Technology R&D Program of Chongqing（No. 2008AB6096，2008AA6024）

Simulation and Experiment on Heat Balance Process in Lubrication System of a Heavy-duty Automobile Transmission

Ruan Dengfang1;Liu Bo1;Chen Zhiyue2;Zhang Xuyong2;Zhang Yong2

1.The State Key Laboratory of Mechanical Transmission,Chongqing University,Chongqing,400030

2.Qijiang Gear Company,Chongqing,401421

Online:2011-05-25 Published:2011-05-31
Supported by:
Key Technology R&D Program of Chongqing（No. 2008AB6096，2008AA6024）

摘要/Abstract

摘要：

在分析重型汽车变速器内元件的产热量与传热过程的基础上，建立了基于AMEsim软件的某重型汽车变速器润滑系统热平衡仿真模型,完成了不同工况条件下润滑系统的热平衡仿真与直接挡空载条件下的试验验证。结果表明：变速器在高速小负荷和高速大负荷工况下工作时，润滑油液的平衡温度均远低于变速器能正常工作的极限温度;在1挡大负荷条件下运行时,润滑油液温度上升较快,在约30min时达到设计要求的最高温度;直接挡空载条件下润滑油平衡温度的仿真结果与实验测试结果较一致,相对误差小于2%。

关键词:

重型汽车, 变速器, 热平衡, 润滑

Abstract:

On the basis of analyses on the power losses and the heat transfer in lubrication system of a heavy-duty automobile transmission,a heat balance simulation model for the lubrication system was established with the software AMEsim and then the simulations were completed under several operation conditions.In order to verify the simulation model, an experiment was conducted at no-load and in direct drive.

The results show that the balance temperature at high-speed and light-load or high-speed and high-load is much lower than the highest temperature at which the transmission can operate normally; the temperature of the lubricating oil goes up very quickly and reaches the limiting value in about 30 minutes at high load and in first gear; the simulation results of the balance temperature are coincide well with the experimental ones at no-load and in direct drive, and the relative error is less than 2%.

Key words:

heavy-duty automobile, transmission, heat balance, lubrication

中图分类号:

U463

阮登芳1, 刘波1, 陈志约2, 张绪勇2, 张勇2.

重型汽车变速器润滑系统热平衡仿真与实验

[J]. 中国机械工程, 2011, 22(10): 1242-1246.

RUAN De-Fang-1, LIU Bei-1, CHEN Zhi-Di-2, ZHANG Xu-Yong-2, ZHANG Yong-2.

Simulation and Experiment on Heat Balance Process in Lubrication System of a Heavy-duty Automobile Transmission

[J]. China Mechanical Engineering, 2011, 22(10): 1242-1246.

参考文献

[1]许翔,毕小平.车用齿轮传动箱的传热仿真模型[J].机械传动,2003,27(5):1-4.
[2]吴昌林[1],余联庆[2].汽车变速箱的热网络分析[J].华中理工大学学报,1998,26(4):63-66.
[3]霍晓强 [1],马彪 [1],刘华琳 [2].综合传动装置箱体的热负荷特性研究[J].工程机械,2005,36(2):27-29.
[4]陈晓玲[1],张武高[1],黄智勇[2],周平[2].高速列车传动齿轮箱热分析的建模与仿真[J].系统仿真学报,2007,19(23):5546-5548.
[5]Diab Y, Ville F, Velex P. Investigations on Power Losses in High--speed Gears[J]. Proc. IMechE Part J :Journal of Engineering Tribology, 2006,220 : 191-198.
[6]Anerson N E, Loewenthal S H. Design of Spur Gears for Improved Efficiency[J]. Journal of Me- chanical Design, 1982,104 : 767-774.
[7]Wu S F,Cheng H S. A Friction Model of Partial-- EHL Contacts and Its Application to Power Loss in Spur Gears [J]. Tribology Transactions, 1991, 34 (3) :398-407.
[8]Anderson N E,Loewenthal S H. Effect of Geometry and Operating Conditions on Spur Gear System Power Loss[J]. Journal of Mechanical Design, 1981. 103:151-159.
[9]Martin K F. The Efficiency of Involute Spur Gears [J]. Journal of Mechanical Design, 1981,103: 160- 169.
[10]Martin K F. A Review of Friction Predictions in Gear Teeth[J]. Wear, 1978,49 : 201-238.
[11]Changenet C, Velex P. A Model for the Prediction of Churning Losses in Geared Transmissions- preliminary Results[J]. Journal of Mechanical De- sign, 2007,129: 128-133.
[12]Luke P, Olver A V. A Study of Churning Losses in Dip- lubricated Spur Gears [ J]. Proc. Instn. Mech. Engrs. ,1999,213:337-346.
[13]Seetharman S, Kahraman A. Load -- independent Spin Power Losses of a Spur Gear Pair: Model Formulation[J]. Journal of Tribology, 2009,131 : 0222011-11.
[14]霍晓强[1],吴传虎[2].齿轮传动系统搅油损失的试验研究[J].机械传动,2007,31(1):63-65. 0
[15]Seetharman S,Kahraman A,Moorhead M D,et al. Churning Power Losses of a Gear Pair:Experi- ments and Model Validation[J]. Journal of Tribol- ogy,2009,131(2) :0222021-10.
[16]克柳科夫Д.运输车辆传动系的热计算[M].万耀青,译.北京:国防工业出版社,1965.
[17]Seetharman S, Velex P. Housing Influence on Churning Losses in Geared Transmissions [J]. Journal of Mechanical Design, 2008,130 : 1-6.