沟槽形表面织构对摩擦噪声的影响

中国机械工程 ›› 2012, Vol. 23 ›› Issue (18): 2233-2237.

沟槽形表面织构对摩擦噪声的影响

单欢乐1;莫继良1;陈光雄1;邵天敏2;周仲荣1

1.西南交通大学,成都,610031
2.清华大学摩擦学国家重点实验室,北京,100084

出版日期:2012-09-25 发布日期:2012-09-29
基金资助:
国家自然科学基金资助项目(51005191);中央高校基本科研业务费专项资金资助（SWJTU09CX015）
National Natural Science Foundation of China（No. 51005191）;
Fundamental Research Funds for the Central Universities( No. SWJTU09CX015 )

#br# #br# Effects of Grooved Surface Texture on Friction Noise

Shan Huanle1;Mo Jiliang1;Chen Guangxiong1;Shao Tianmin2;Zhou Zhongrong1

1.Southwest Jiaotong University,Chengdu,610031
2.State Key Laboratory of Tribology,Tsinghua University,Beijing,100084

Online:2012-09-25 Published:2012-09-29
Supported by:

National Natural Science Foundation of China（No. 51005191）;
Fundamental Research Funds for the Central Universities( No. SWJTU09CX015 )

摘要/Abstract

摘要：

用电加工方法在制动盘蠕墨铸铁材料表面加工出沟槽形表面织构（沟槽深度为30μm、宽度为150μm、间距为500μm）,采用球—平面接触方式，选取直径为10mm的Si3N4球为对磨副，对沟槽形织构表面和光滑表面进行了摩擦噪声对比试验，研究了沟槽形表面织构对界面摩擦振动噪声的影响。试验结果表明（以下结论只针对本试验选定尺寸规格的沟槽形表面织构）：法向载荷对织构表面产生摩擦噪声强度的影响较小，而对光滑表面产生摩擦噪声的水平具有重要影响;沟槽形织构表面在低法向载荷下较光滑表面更易产生摩擦噪声，但随着法向载荷从5N增大到10N,光滑表面产生的摩擦噪声强度迅速增大并与织构表面的接近;沟槽形表面织构使摩擦系统更易产生多频率的摩擦振动，较早地产生摩擦噪声且其主频率成分较复杂;沟槽形织构表面比光滑表面具有较高的摩擦因数和耐磨性,沟槽形织构的存在明显地改变了接触界面摩擦磨损行为和摩擦噪声特性，但其对应关系需要进一步深入研究。



关键词: 表面织构, 摩擦噪声, 摩擦振动, 摩擦磨损

Abstract:

Grooved surface texture was manufactured on the surface of compacted graphite iron samples(brake disc material) by electromachining,with the grooves of 30μm in depth,150μm in width and 500μm in pitch.Comparative friction noise tests between groove-textured and smooth surfaces were performed in a ball-on-flat configuration by using Si3N4 ball with diameter of 10mm as counterpart and the influence of grooved surface texture on friction noise was investigated.The test results (applicable only to the grooved surface texture adopted herein) show that the normal load has little influence on the friction noise level of the groove-textured surface,but significant influence on that of the smooth surface.Friction noise has a greater tendency to be generated at the groove-textured surface under low normal load.However,friction noise generated at the smooth surface increases its level rapidly approaching to that of the groove-textured surface,as the normal load increases from 5N to 10N.The grooved surface texture makes the friction system easier to generate multi-frequency friction vibration,and thus earlier friction noise with more dominant frequency components.The groove-textured surface has higher coefficient of friction and wear resistance as compared to the smooth surface.The existence of surface texture does change the fiction and wear behaviors as well as friction noise properties of the frictional surfaces, but their corresponding relationship requires further study.

Key words: surface texture, friction noise, friction vibration, friction and wear

中图分类号:

TH117.1

单欢乐1, 莫继良1, 陈光雄1, 邵天敏2, 周仲荣1. 沟槽形表面织构对摩擦噪声的影响[J]. 中国机械工程, 2012, 23(18): 2233-2237.

CHAN Huan-Le-1, MO Ji-Liang-1, CHEN Guang-Xiong-1, SHAO Tian-Min-2, ZHOU Zhong-Rong-1. #br# #br# Effects of Grooved Surface Texture on Friction Noise[J]. China Mechanical Engineering, 2012, 23(18): 2233-2237.

参考文献

[1]周燕.摩擦噪声与降噪技术研究[M].北京:机械科学研究院,2006.
[2]陈光雄.金属往复滑动摩擦噪声的研究[D].西南交通大学,2002:
[3]Ben Abdelounis H, Le Bot H, Perret-- Liaudet J, et al. An Experimental Study on Roughness Noise of Dry Rough Flat Surfaces[J]. Wear, 2010,268 : 335- 345.
[4]Hammersrom L,Jacobson S. Surface Modification of Brake Discs to Reduce Squeal Problems[J]. Wear, 2006,261:53-57.
[5]Bergman F, Eriksson M, Jacobson S. Influence of Disc Topography on Generation of Brake Squeal[J].Wear,1999,255/259:621-628.
[6]Chen G X,Zhou Z R,Kapsa P,et al. Effect of Sur- face Topography on Formation of Squeal under Re ciprocating Sliding[J]. Wear, 2002,253 : 411-423.
[7]Othman M O, Elkholy A H. Surfaces Roughness Measuring Using Dry Friction Noise[J]. Exp. Mech. , 1990,47:309-312.
[8]Stoimenov B L,Maruyama S, Adashi K,et al. The Roughness Effect on the Frequency of Frictional Sound[J]. Tribol. Int. , 2007,40 : 659-664.
[9]任露泉,王再宙,韩志武.仿生非光滑表面滑动摩擦磨损试验研究[J].农业机械学报,2003,34(2):86-88.
[10]万轶[1],熊党生[1].激光表面织构化改善摩擦学性能的研究进展[J].摩擦学学报,2006,26(6):603-607.
[11]历建全[1],朱华[1].表面织构及其对摩擦学性能的影响[J].润滑与密封,2009,34(2):94-97. 6
[12]马晨波[1],朱华[2],张文谦[2],姬翠翠[2].往复条件下织构表面的摩擦学性能研究[J].摩擦学学报,2011,31(1):50-55.
[13]Ryk G,Etsion I. Testing Piston Rings with Partial Laser Surface Texturing for Friction Reduction[J]. Wear,2006,261:792-796.
[14]Pradeep L Menezes,Kishore, Satishv V Kailas. In- fluence of Surface Texture and Roughness Parame- ters on Friction and Transfer Layer Formation during Sliding of Aluminium Pin on Steel Plate [J]. Wear, 2009,267 : 1534-1549.
[15]Ibrahim R A. Friction--induced Vibration, Chat ter, Squeal, and Chaos, Part 2 : Dynamics and Mod eling[J]. Applied Mechanics Review, 1994,47 : 227-253.
[16]Suh N P, Sin H C. The Genesis of Friction[J]. Wear, 1981,69:91-114.