基于模态测试的航空管道动力学响应实验与分析

中国机械工程 ›› 2012, Vol. 23 ›› Issue (16): 1925-1929.

基于模态测试的航空管道动力学响应实验与分析

鲁华平1,2;贾普荣1;刘永寿1;孙波2;李宝辉1

1.西北工业大学,西安,710072
2.空军航空大学,长春,130022

出版日期:2012-08-25 发布日期:2017-05-27
基金资助:
航空科学基金资助项目(2011ZA53014);西北工业大学基础研究基金资助项目(JC201114）
Aviation Science Foundation of China（No. 2011ZA53014）

#br# Dynamics Response Experiment and Analysis of Aviation Pipeline Based on Modal Test

Lu Huaping1,2;Jia Purong1;Liu Yongshou1;Sun Bo2;Li Baohui1

1.Northwestern Polytechnical University,Xi'an,710072
2.Aviation University of Air Force,Changchun,130022

Online:2012-08-25 Published:2017-05-27
Supported by:
Aviation Science Foundation of China（No. 2011ZA53014）

摘要/Abstract

摘要：

航空管道是影响飞行安全的关键件之一,针对其动力学特性分析中阻尼比的影响问题,对某航空铝合金管道采用MIMO模态测试,得到其前八阶模态频率和阻尼比;对该管道施加瞬态激励,得到不同点处的时域响应数据;考虑了传感器的附加质量,计算了模态频率,分别基于恒定阻尼比和实验得到的模态阻尼比模型,分析了管道瞬态动力学响应特性,并与实测响应数据进行对比分析。结果表明：采用模态阻尼比计算得到的管道动力学响应不论是响应时间还是响应大小都更接近于实测值,对于航空管道这种安全性要求很高的结构,应尽可能采用模态阻尼比进行计算分析。



关键词: 航空管道, 模态测试, 阻尼比, 动力学响应

Abstract:

Aviation pipeline is one of the key components of aircraft;aimed at the influences of damping ratio in dynamics computation,based on MIMO modal test,a pipeline,made of aviation aluminum alloy,its first eight order modal frequencies and damping ratios were obtained.In addition,the pipeline was excited by instantaneous loads and the response data in some regions were gotten in time domain.The mode frequencies were calculated by taking into account the added mass caused by acceleration sensors.Respectively,based on constant damping ratio and modal damping ratio of testing mode,the instantaneous dynamic responses of the pipeline were analyzed and compared with test values.The results show that both of dynamics response amplitudes and the response times in calculation based on modal damping ratio are
closer to test values of the aviation pipeline,it is better than that of the calculated values based on constant damping ratio.The structure with high security requirements,such as aviation pipeline,its response should be calculated based on the modal damping ratio as far as possible. 

Key words: aviation pipeline, modal test, damping ratio, dynamics response

中图分类号:

O327
TB123

鲁华平1, 2, 贾普荣1, 刘永寿1, 孙波2, 李宝辉1. 基于模态测试的航空管道动力学响应实验与分析[J]. 中国机械工程, 2012, 23(16): 1925-1929.

LU Hua-Beng-1, 2, GU Pu-Rong-1, LIU Yong-Shou-1, SUN Bei-2, LI Bao-Hui-1. #br# Dynamics Response Experiment and Analysis of Aviation Pipeline Based on Modal Test[J]. China Mechanical Engineering, 2012, 23(16): 1925-1929.

[1]	宾光富, 周伟, 王钢, 陈文. 基于附加约束的小型涡轮增压器转子模态测试[J]. 中国机械工程, 2017, 28(11): 1274-1278.
[2]	左希庆, , 阮健, 孙坚, 李胜, 刘国文. 基于挤压油膜理论的二维电液压力伺服阀稳定性分析[J]. 中国机械工程, 2017, 28(05): 537-543.
[3]	胡俊峰1;张宪民2. 基于μ综合的压电柔性结构振动主动控制[J]. 中国机械工程, 2014, 25(2): 147-151,156.
[4]	隋成国, 许锋, 聂宏. 舰载机弹射起飞动力学虚拟试验研究[J]. 中国机械工程, 2013, 24(4): 522-527.
[5]	张磊安, 黄雪梅. 大型风机叶片模态参数识别的试验研究[J]. 中国机械工程, 2013, 24(17): 2328-2331.
[6]	肖闯, 殷智宏. 三维随行电缆简化模型有限元建模与模态实验[J]. 中国机械工程, 2012, 23(16): 1934-1938.
[7]	孙丽波;许立忠;. 微板机电耦合非线性动力学分析[J]. J4, 2009, 20(16): 0-2015.
[8]	刘善增;;余跃庆;佀国宁;刘庆波;杨建新;. 3-RRS柔性并联机器人的动力学分析[J]. J4, 2009, 20(07): 0-762.