Modeling and Analysis of Digital Hydraulic Cylinder Based on Transfer Function

China Mechanical Engineering ›› 2014, Vol. 25 ›› Issue (1): 65-70.

Previous Articles Next Articles

Modeling and Analysis of Digital Hydraulic Cylinder Based on Transfer Function

Chen Jia;Xing Jifeng;Peng Likun

Naval University of Engineering，Wuhan，430033

Online:2014-01-10 Published:2014-01-14
Supported by:
National Defense Pre-research Foundation of General Armament Department（No.40103050210102）

基于传递函数的数字液压缸建模与分析

陈佳;邢继峰;彭利坤

海军工程大学，武汉，430033

基金资助:
军队“十二五”预研基金资助项目（40103050210102）

Abstract

Abstract:

Considering power match and characteristics of asymmetrical structure, setting the position with the minimum hydraulic spring stiffness as the orginal point, a transfer function of valve-controlled asymmetrical cylinder was deduced, a reasonable expression to count hydraulic natural frequency was given, and then a universal transfer function model of the digital hydraulic cylinder was established. Based on the model, meaning of parameters and system characteristics were analysed. And using real parameters, confirmatory simulation experiments were carried out. The results reveal that, load and the asymmetrical structure of digital hydraulic cylinder account for the performance differences between the two motion directions-positive and negative. System performance is decided by the structural characteristics of inner feedback loop, and the good stability is showed.

Key words: digital hydraulic cylinder, hydraulic spring stiffness, transfer function model, system characteristics

摘要：

在考虑功率匹配和非对称结构特性的基础上，以液压弹簧刚度最小位置为工作点，推导了阀控非对称缸的传递函数，给出了合理的液压固有频率计算公式，建立了通用的数字液压缸传递函数模型。利用所建模型，分析了参数意义和系统特性，并结合具体参数进行了仿真验证。结果表明，受负载和非对称结构影响，数字液压缸正反向运动特性存在差异;系统性能由内反馈回路的结构参数决定，系统稳定性良好。

关键词: 数字液压缸, 液压弹簧刚度, 传递函数模型, 系统特性

CLC Number:

TH137

Chen Jia, Xing Jifeng, Peng Likun. Modeling and Analysis of Digital Hydraulic Cylinder Based on Transfer Function[J]. China Mechanical Engineering, 2014, 25(1): 65-70.

陈佳, 邢继峰, 彭利坤. 基于传递函数的数字液压缸建模与分析[J]. 中国机械工程, 2014, 25(1): 65-70.

References

[1]吕云篙．阀控非对称缸频域建模[J]．机械工程学报，2007，43(9)：122-126．
Lü Yunsong．Modeling in Frequency Domain for Valve Controlled Asymmetric Hydraulic Cylinders[J]．Journal of Mechanical Engineering，2007，43(9)：122-126．
[2]Guo Bo，Li Yugui，Han Heyong．Analysis of Asymmetric Valve Control Asymmetric Cylinder System of Hydraulic Leveler[J]．Advanced Materials Research，2011，145：477-480．
[3]裴翔，李胜，阮健，等．2D数字伺服阀的频响特性分析[J]．机床与液压，2001(4)：11-13．
Pei Xiang，Li Sheng，Ruan Jian，et al．Investigation to Frequency Response of 2D Digital Servo Valve[J]．Machine Tool & Hydraulics，2001(4)：11-13．
[4]段英宏，杨硕．步进电动机的模糊PID控制[J].计算机仿真，2006，23(2)：290-293．
Duan Yinghong，Yang Shuo．Fuzzy-PID Control of Stepping Motor[J]. Computer Simulation，2006，23(2)：290-293．
[5]Yao Bin，Bu Fanping，Reedy J，et al．Adaptive Robust Motion Control of Single-rod Hydraulic Actuators： Theory and Experiments[J]．IEEE/ASME Transactions on Mechatronics，2000，5(1)：79-91．
[6]叶小华，岑豫皖，赵韩，等．基于液压弹簧刚度的阀控非对称缸建模仿真[J]．中国机械工程，2011，22(1)：23-27．
Ye Xiaohua，Cen Yuwan，Zhao Han，et al．Modeling and Simulation of Hydraulic Spring Stiffness-based Asymmetrial Cylinder Controlled by Valve[J]．China Mechanical Engineering，2011，22(1)：23-27．
[7]肖志权，邢继峰，彭利坤．再论负载流量与负载压力[J]．机床与液压，2007，35(1)：130-133．
Xiao Zhiquan，Xing Jifeng，Peng Likun．Further Study of Load Flow and Load Pressure[J]．Machine Tool & Hydraulics，2007，35(1)：130-133．
[8]李洪人．液压控制系统[M]．北京：国防工业出版社，1990．
[9]宋志安．基于MATLAB的液压伺服控制系统分析与设计[M]．北京：国防工业出版社，2007．
[10]明廷涛，张永祥，孙云岭．液压伺服系统的H-∞观测器设计[J]．海军工程大学学报，2009(6)：84-89．
Ming Tingtao，Zhang Yongxiang，Sun Yunling．Design of H-∞ Observer for Hydraulic Servo System[J]．Journal of Naval University of Engineering，2009(6)：84-89．

Modeling and Analysis of Digital Hydraulic Cylinder Based on Transfer Function

基于传递函数的数字液压缸建模与分析

PDF

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 2

Recommended Articles

Metrics

[1]	QI Panguo, LIU Zhengqi, ZHAO Liwei, ZHANG Xingyuan, ZHAO Lijuan. Research on Problem of Feedback Mechanism Clearances of a Digital Hydraulic Cylinder for Shearer Rocker Arms [J]. China Mechanical Engineering, 2023, 34(02): 172-184.
[2]	XIE Xiao-Hua-, CEN Shu-Huan-2 DIAO Han XIE Jin-Jie. Modeling and Simulation of Hydraulic Spring Stiffness-based Asymmetrical Cylinder Controlled by Valve [J]. China Mechanical Engineering, 2011, 22(1): 23-27.